Therma-Tru Window Replacement Nationwide

Therma-Tru Window Replacement: The Santa Clarita Owner’s Guide

Therma-Tru window replacement in Santa Clarita typically runs $450 to $1,200 installed per window, depending on the sash, glass package, and how much of the frame needs attention. We stock common Therma-Tru replacement parts on our trucks and can usually have the job buttoned up the same day we diagnose it. Most homeowners discover a problem the same way: a sash that suddenly won’t stay up, condensation fogged between the panes, or a latch that no longer seats tight against the seal.

Call (661) 523-0347

Juniper Windows Santa Clarita is an independent service provider, not affiliated with Therma-Tru. What that means in practice: we match your existing Therma-Tru unit to OEM or equivalent parts, give you a written price before any work begins, and stand behind the install for 365 days, parts and labor, in writing.

Key Takeaways

• Typical installed cost: $450 to $1,200 per window in Santa Clarita, depending on sash condition and glass type.
• Same-day replacement is common when we have the sash or hardware on the truck, and we stock Therma-Tru compatible parts in our Santa Clarita service area.
• 365-Day Done Right Promise: every Therma-Tru window replacement we install is covered in writing for a full year.
• Written price before work starts: no estimate that morphs into a surprise invoice at the door.

Which Therma-Tru Models This Applies To

Therma-Tru builds a few distinct window lines, and the replacement path depends on which one you have. The most common units we see in Santa Clarita homes are the Therma-Tru casement and picture windows paired with their fiberglass entry doors, along with the sliding patio door sashes that share hardware with the window lines. If you have a Therma-Tru double-hung, the tilt-in sash mechanism is the part that typically goes first; the pivot pins and balance shoes wear down faster than anything else on the frame.

To match the right part, look for the labels etched into the corner of the glass or on the hinge hardware. Most Therma-Tru units carry a small engraving with the series name and a date code, often starting with letters like “TT” followed by four digits. If that label is worn off or painted over, we measure the visible glass dimensions and the sash thickness, then compare against Therma-Tru’s replacement specs. On OEM versus aftermarket: Therma-Tru factory glass packages preserve the original U-factor and Solar Heat Gain numbers, which matters if you’re chasing energy savings on a Santa Clarita summer afternoon. Quality aftermarket equivalents from our suppliers can match those numbers, but only if the glass thickness and low-e coating spec are right. We verify both before anything goes in.

Signs Your Therma-Tru Window Replacement Is Failing

• Fogged or milky glass between the panes. The inert gas between the panes has escaped, and the window’s insulating ability is gone. This is a sealed-unit failure and usually requires glass replacement rather than a full-frame tear-out.
• Sash that won’t stay open or closed. Worn pivot pins, broken balance shoes, or a fatigued coil spring are the usual culprits on Therma-Tru double-hungs. It is not a lubrication problem; the hardware needs replacement.
• Visible daylight or a draft at the closed edge. The compression seal or weatherstripping on a Therma-Tru casement has compressed beyond recovery, and in Santa Clarita’s dry heat, that material gets brittle years before it does in a coastal climate.
• Lock or latch that no longer seats. The keeper or the lock mechanism itself has loosened or bent. On a security-conscious window line, that means the unit is not locking tight against forced entry.
• Condensation inside the room on the glass surface. That usually signals the inner seal has failed and moist air is bypassing the low-e coating. It will get worse in winter mornings when the Santa Clarita temperature swings from the 40s to the 70s.

Replacement Cost & What’s Included

For most Therma-Tru window replacements in Santa Clarita, plan on $450 to $750 for a sealed glass unit swap with new sash hardware, and $800 to $1,200 when the full sash or sliding panel needs replacement. Here is how the cost breaks down:

• Glass-only sealed unit replacement: $300 to $500 installed per window, including new gasketing.
• Sash replacement with matching glass package: $450 to $800 installed, including pivot pins, balance shoes, and tilt-latch hardware.
• Full-frame replacement for heavily damaged Therma-Tru units: $900 to $1,200 installed, which includes new interior trim and re-caulking the exterior perimeter.

What drives the range: the size of the unit, whether the glass is a standard clear package or upgraded low-e, and how much of the existing frame is salvageable. Every quote we write in Santa Clarita is a fixed price, in writing, before the first screw turns. If the work is not right, the 365-Day Done Right Promise means we fix it for free, parts and labor, for a full year after installation.

DIY or Call Us?

You can safely do a few things before calling: write down the label information from the glass corner, take a photo of the Hardware, and measure the visible glass width and height to the nearest 1/8 inch. That helps us tell you over the phone whether we are likely to have the matching part on the truck.

What you should not do is attempt a sash removal on a Therma-Tru double-hung without the right tilt-in procedure. Forcing the sash out of the jamb can bend the pivot pins, mark the finish, and turn a $500 repair into a $1,200 full-frame job. And do not try to replace a sealed glass unit yourself; the glazing bead has to go back in square, with even pressure, or the seal will fail again within months. Sean Mackey will tell you the same thing he tells our Santa Clarita customers: “A window that leaks air is just an expensive hole in your wall – let’s do it right the first time.” Call (661) 523-0347 and we will schedule a free estimate, written price included.

FAQs